We don't have official assembly instructions, but attached is the PDF spec sheet, and below are some tips to help!
- The legs of the bench that touch the floor have rubber caps. Those caps just pop on or off. On the pdf, we call these the "no-slip rubber feet".
- The middle of the legs in the center of the "X" are knobs that can help you collapse the legs or tighten them to keep them in place. On the pdf, this is called the "Collapsable legs".
- The legs of the bench that attach to the seat have a spring-loaded mechanism that goes into the holes on the bottom of the seat. On the pdf, we call this the "Locking adjustment feature". Use the holes on the bottom of the seat that give you the right height you desire for your bench.
- Once the bench is attached to the legs, make sure it's the height you like, then tighten all the knobs and you're good to go!
Comments
0 comments
Article is closed for comments.